Figure 78. Installing system board
Next steps
1. Replace the following:
a. Trusted Platform Module (TPM).
b. Internal Perc card or Front PERC riser.
c. Expansion card riser.
d. Processor(if removed).
e. Heatsink(if removed).
f. Memory modules(if installed).
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Install the air shroud.
4. Install the system cover.
5. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the Restoring the system by using the Easy Restore
feature section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the Manually
update the Service Tag by using System Setup section.
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). See the Upgrading the Trusted Platform Module section.
6. Follow the procedure listed in After working inside your system.
Restoring the system using Easy Restore
The Easy Restore feature enables you to restore your service tag, license, UEFI configuration, and the system configuration data
after replacing the system board. All data is backed up in a backup flash device automatically. If BIOS detects a new system
board, and the service tag in the backup flash device, BIOS prompts the user to restore the backup information.
Installing and removing system components
105
To Next Page
Loading...
