Dell PowerEdge R360 - Cooling Fans; Removing the Cooling Fan

NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud into the system until it is firmly seated.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 19. Installing air shroud
Next steps
1. Install the system cover.
2. Follow the procedure listed in After working inside your system.
Cooling fans
Removing the cooling fan
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
Steps
1. Press the release tabs on the fan cable connector and disconnect the cable from the system board.
2. Lift the cooling fan from the cooling fan cage.
Installing and removing system components
55