Steps
1. Pull up on the plunger to disengage the PIB from the chassis floor.
2. Slide the PIB back and lift from the system .
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 75. Removing the PIB
Next steps
Install the PIB.
Installing the PIB
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
4. Remove the power supply unit.
Steps
1. Align the guide slots on the PIB with the four hooks on the system.
2. Slide PIB in to the guide hooks till the plunger click in place .
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
102 Installing and removing system components
To Next Page
Loading...
