Dell PowerEdge R360 - Storage Controller Specifications; Drives; GPU Specifications; Ports and Connectors Specifications

Storage controller specifications
The PowerEdge R360 system supports the following controller cards with a maximum of one internal controller and one external
controller:
Table 13. Storage controller cards 
Supported storage controller cards
Internal controllers
● PERC H355
● PERC H755
● PERC H355 Front
● PERC H755 Front
External controllers
● HBA355e
Software RAID
● S160
Internal Boot
● Boot Optimized Storage Subsystem (BOSS-N1): HWRAID 2 x M.2 NVMe SSDs
SAS Hot Bus Adapters (HBA)
● HBA355i, HBA355i Front
Drives
The PowerEdge R360 system supports:
Front Drives
● 8 x 2.5-inch hot-swappable SAS,SATA drives through PERC
● 4 x 3.5-inch hot-swappable SAS,SATA drives through PERC
● 4 x 3.5-inch hot-swappable SATA drives through chipset
GPU specifications
The PowerEdge R360 system supports one 60 W low profile Nvidia A2 GPU on the riser.
NOTE: Systems configured with GPUs will have higher fan acoustics.
NOTE: The R360 with GPU configuration is not recommended for an acoustic sensitive environment (Office environment,
or general use space etc.).
Ports and connectors specifications
NIC port specifications
The PowerEdge R360 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on
the LAN on Motherboard (LOM).
Table 14. NIC port specification for the system
Feature Specifications
LOM 1 Gb x 2
22 Technical specifications