Figure 22. Removing the intrusion switch
Next steps
1. Install the intrusion switch.
2. Follow the procedure listed in After working inside your system.
.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove system cover.
4. Remove air shroud.
Steps
1. Align and slide the intrusion switch into the guide pin on the chassis.
2. Tighten the screw to secure the intrusion switch to the chassis.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
58 Installing and removing system components
To Next Page
Loading...
