Dell PowerEdge R360 - Removing an Expansion Card from the Riser

Table 65. Riser configurations: System without riser - Configuration 0 SAS/SATA 
Card type Slot Priority Maximum number of cards
FOXCONN (aPERC 11) Integrated slot 1
FOXCONN (FPERC 11) Integrated slot 1
FOXCONN (aPERC HBA11) Integrated slot 1
FOXCONN (FPERC HBA11) Integrated slot 1
FOXCONN (aPERC 11) Integrated slot 1
FOXCONN (FPERC 11) Integrated slot 1
FOXCONN (BOSS-N1) Integrated slot 1
FOXCONN (BOSS-N1) Integrated slot 1
Table 66. Riser configurations: System with butterfly riser : Configuration 1
Card type Slot Priority Maximum number of cards
FOXCONN (GPU) 1 1
FOXCONN (GPU) 1 1
FOXCONN (aPERC 11) Integrated slot 1
FOXCONN (FPERC 11) Integrated slot 1
FOXCONN (aPERC HBA11) Integrated slot 1
FOXCONN (FPERC HBA11) Integrated slot 1
FOXCONN (External Adapter) 2,1 2
FOXCONN (External Adapter) 2,1 2
FOXCONN (aPERC 11) Integrated slot 1
FOXCONN (FPERC 11) Integrated slot 1
Broadcom (NIC:1Gb) 1,2 2
Intel (NIC:10Gb) 1,2 2
Intel (NIC:10Gb) 1,2 2
Broadcom (NIC:10Gb) 1,2 2
Broadcom (NIC:10Gb) 1,2 2
Intel (NIC:1Gb) 1,2 2
FOXCONN (BOSS-N1) Integrated slot 1
FOXCONN (BOSS-N1) Integrated slot 1
Removing an expansion card from the riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
4. Remove the expansion card riser.
5. Disconnect any cables that are connected to the expansion card.
82
Installing and removing system components