Steps
If you are installing a second power supply unit, remove the power supply unit blank in the bay by pulling the blank outward.
CAUTION: Proper system cooling, the power supply unit blank must be installed in the second power supply unit
bay in a non-redundant configuration. Remove the power supply unit blank only if you are installing a second
power supply unit.
Figure 71. Removing a power supply unit blank
Next steps
1. Install a power supply blank.
2. Follow the procedure listed in After working inside your system.
Installing a power supply unit blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
Figure 72. Installing a power supply unit blank
Next steps
1. Follow the procedure listed in After working inside your system.
Installing and removing system components
99
To Next Page
Loading...
