Dell PowerEdge R360 - Installing a 2.5-Inch Drive into a 3.5-Inch Drive Adapter

Figure 39. Removing a 2.5 inch drive from a 3.5-inch drive adapter
Next steps
Install 2.5 inch drive into 3.5 inch adapter.
Installing a 2.5-inch drive into a 3.5-inch drive adapter
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
Steps
1. Align the screw holes on the 2.5-inch drive with the screw holes on the 3.5-inch drive adapter.
2. Using a Phillips #2 screwdriver, secure the 2.5-inch drive to the 3.5-inch drive adapter.
NOTE:
If the 2.5-inch drive has a Torx screw, use Torx 6 screwdriver to install the drive to a 3.5-inch drive adapter.
72 Installing and removing system components