Dell PowerEdge R360 - System Battery; Replacing the System Battery

Figure 62. Installing the BOSS N1 blank
Next steps
1. Follow the procedure listed in After working inside your system.
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. For more information, see the
safety information that shipped with your system.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
4. Remove expansion card riser(if installed).
Steps
1. Press and hold the battery socket retention latch, for the battery to pop out. .
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
NOTE: If the battery does not pop out, then lift it out of the socket.
92 Installing and removing system components