3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.
Control panel
This is a service technician replaceable part only.
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
Steps
1. Disconnect the right control panel cable on the system board.
NOTE: Observe the routing of the cable assembly as you remove the right control panel from the system.
2. Using the screwdriver, remove the two screws that secure the right control panel to the system.
3. Holding the right control panel and cable assembly, slide the right control panel out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 80. Removing the right control panel
Next steps
1. Install the right control panel.
108
Installing and removing system components
To Next Page
Loading...
