Figure 38. Installing a drive carrier
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Prerequisites
NOTE: A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier.
Steps
1. Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
NOTE:
If the 2.5-inch drive has a Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive
adapter.
2. Remove the 2.5-inch drive from the 3.5-inch drive adapter.
Installing and removing system components
71
To Next Page
Loading...
