Table 40. HTTP Device n Settings details(continued)
Option Description
VLAN Enables Vlan for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
VLAN ID Shows the Vlan ID for the HTTP device
Vlan Priority Shows the Vlan Priority for the HTTP device.
DHCP Enables or disables DHCP for this HTTP device. This option is set to Enabled by default.
IP Address Specifies IP address for the HTTP device.
Subnet Mask Specifies subnet mask for the HTTP device.
Autoconfiguration Enables or disables the IPv6Autoconfiguration for the HTTP Device. When set to Enabled,
IPv6 Address and Gateway are retrieved from Autoconfiguration mechanism.
Prefix Length IPv6 Prefix Length (0~127) for this HTTP Device.
IPv6 Address IPv6 Unicast address for this HTTP Device.
Gateway Specifies gateway for the HTTP device.
DNS info via DHCP Enables or disables DNS Information from DHCP. This option is set to Enabled by default.
Primary DNS Specifies the primary DNS server IP address for the HTTP Device.
Secondary DNS Specifies the secondary DNS server IP address for the HTTP Device.
URI (will obtain from
DHCP server if not
specified)
Obtain URI from the DHCP server if not specified
TLS Authentication
Configuration
Specifies the option for TLS authentication configuration.
NOTE: Autoconfiguration, Prefix Length and IPv6 Address options are visible only when Protocol is set to IPv6
Table 41. UEFI iSCSI Settings screen details
Option Description
iSCSI Initiator Name Specifies the name of the iSCSI initiator in IQN format.
iSCSI Device1 Enables or disables the iSCSI device. When disabled, a UEFI boot option is created for
the iSCSI device automatically. This is set to Disabled by default.
iSCSI Device1 Settings Enables you to control the configuration of the iSCSI device.
Table 42. ISCSI Device1 Settings screen details
Option Description
Connection 1 Enables or disables the iSCSI connection. This option is set to Disabled by default.
Connection 2 Enables or disables the iSCSI connection. This option is set to Disabled by default.
Connection 1 Settings Enables you to control the configuration for the iSCSI connection.
Connection 2 Settings Enables you to control the configuration for the iSCSI connection.
Connection Order Enables you to control the order for which the iSCSI connections will be
attempted.
Integrated Devices
To view the Integrated Devices screen, power on the system, press F2, and click System Setup Main Menu > System BIOS
> Integrated Devices.
36
Pre-operating system management applications
To Next Page
Loading...
