Dell PowerEdge R360 - PERC Card; Removing the Internal PERC Card; Installing the Internal PERC Card

PERC card
Your system includes dedicated slots on the system board for PERC cards.
Removing the internal PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
4. Remove the expansion card riser (if installed).
Steps
1. Loosen and remove the two screws securing the PERC card.
2. Hold the metal holder, slide the PERC card towards the PSU to remove it from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 65. Removing the internal PERC card
Next steps
1. Install the adapter PERC.
Installing the internal PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
4. Remove the expansion card riser (if installed).
94
Installing and removing system components