Dell PowerEdge R360 - Installing the BOSS N1 Module

Figure 57. Removing the BOSS N1 card
Next steps
1. Install the BOSS N1 module or Install the BOSS N1 blank.
Installing the BOSS N1 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove system cover.
4. Remove air shroud.
5. Remove the BOSS N1 blank.
Steps
1. Insert the BOSS N1 card in to the cage.
2. Tighten the two screws to secure the BOSS N1 card to the cage.
88
Installing and removing system components