Steps
Hold the expansion card by the edges and pull it to disengage from the connector .
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 50. Removing an expansion card from the riser
Next steps
Install the expansion card into the riser.
Installing the expansion card in to the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Remove the expansion card riser.
Steps
1. If installed, remove the filler bracket.
NOTE:
Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 83
To Next Page
Loading...
