Figure 54. Installing the riser
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
Optional BOSS-N1 module
Removing the BOSS N1 module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working on your system.
3. Remove air shroud.
Steps
1. Disconnect the cables from the BOSS N1 module.
2. Lift the retention latch to unlock the BOSS N1 M.2 module.
3. Pull the BOSS N1 M.2 module out from the rear of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
86 Installing and removing system components
To Next Page
Loading...
