Figure 85. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. To install the BOSS-N1 module , see Install the BOSS N1 module .
NOTE: Refer to cable routing section for BOSS N1 cable connections.
NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
NOTE: BOSS N1 module cannot be installed if the system has an internal adapter PERC card installed.
114 Upgrade Kits
To Next Page
Loading...
