Figure 67. Removing the front PERC card
3. Press the release clip and remove the cable from the PERC module.
NOTE:
Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it
to prevent the cable from being pinched or crimped.
4. Loosen and remove the screw securing the front PERC riser.
5. Slide the front PERC riser towards the PSU and lift from the system..
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 68. Removing the front PERC card riser
96
Installing and removing system components
To Next Page
Loading...
