Dell PowerEdge R6615 9JNDF - Page 106

Figure 78. Configuration 4-9: 10 x U.2 G4
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 80. 10 x U.2 G4
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL1 (signal connector on system board) CTRL_DST_PA1 (front PERC)
3 SL2 (signal connector on system board) CTRL_DST_PB1 (front PERC)
4 SL3 (signal connector on system board) CTRL_DST_PA2 (front PERC)
5 SL7 (signal connector on system board) BP_DST_PB2 (backplane signal connector)
6 SL8 (signal connector on system board) BP_DST_PA3 (backplane signal connector)
106 Installing and removing system components