Figure 80. Configuration 4-12: 10 x 2.5-inch SAS4/SATA RAID with Rear 2 x E3.S G5x4 (with FPERC 12)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 82. 10 x 2.5-inch SAS4/SATA RAID with Rear 2 x E3.S G5x4 (with FPERC 12)
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power
connector)
2 SL1 (signal connector on system board) CTRL_DST_PA1 (front PERC)
3 SL3 (signal connector on system board) CTRL_DST_PA1 (front PERC)
4 BP_DST_SB1 (backplane signal connector) CTRL_SRC_SB1 (front PERC)
5 BP_DST_SA1 (backplane signal connector) CTRL_SRC_SA1_PA1 (front PERC)
6 SIG_PWR_0 (system board power connector) R_BP_PWR_1 (rear backplane power
connector)
7 SL9 (signal connector on system board) R_BP_DST_PA1 (rear backplane signal
connector)
108 Installing and removing system components
To Next Page
Loading...
