Figure 81. Configuration 4-13: 10 x U.2 G4 with Rear 2 x E3.S G5x4
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 83. 10 x U.2 G4 with Rear 2 x E3.S G5x4
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL1 (signal connector on system board) BP_DST_PA1 (backplane signal connector)
3 SL2 (signal connector on system board) BP_DST_PB1 (backplane signal connector)
4 SL3 (signal connector on system board) BP_DST_PA2 (backplane signal connector)
5 SL7 (signal connector on system board) BP_DST_PB2 (backplane signal connector)
6 SL8 (signal connector on system board) BP_DST_PA3 (backplane signal connector)
7 SIG_PWR_0 (system board power connector) R_BP_PWR_1 (rear backplane power connector)
8 SL9 (signal connector on system board) R_BP_DST_PA1 (rear backplane signal connector)
Installing and removing system components 109
To Next Page
Loading...
