Dell PowerEdge R6615 9JNDF - Page 110

Figure 82. Configuration 5-3: 14 x E3.S G5x4
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 84. 14 x E3.S G5x4
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
3 SL1 (signal connector on system board) BP_DST_PA2 (backplane signal connector)
4 SL2 (signal connector on system board) BP_DST_PB1 (backplane signal connector)
5 SL3 (signal connector on system board) BP_DST_PB2 (backplane signal connector)
6 SL4 (signal connector on system board) BP_DST_PA1 (backplane signal connector)
7 SL7 (signal connector on system board) BP_DST_PA1 (backplane signal connector)
8 SL8 (signal connector on system board) BP_DST_PB1 (backplane signal connector)
9 SL9 (signal connector on system board) BP_DST_PB2 (backplane signal connector)
110 Installing and removing system components