125
Advanced Setup – Part 2
4
Press the CURSOR
DD
or
HH
button to select the
Equalizer curve, then press the
ENTER button.
• Display the “EQ Check” screen.
The display is only an approximate picture of the
response and that correction is happening at all
frequencies.
5
Press the CURSOR
FF
or
GG
button to select the
speaker channel.
6
If the check ends, pressing the CURSOR
DD
or
HH
button to select the “Exit”, then press the
ENTER button.
• The “EQ Parameter Check” screen reappears.
9
Press the CURSOR
DD
or
HH
button to select the
“Exit”, then press the
ENTER button.
• The “Auto Setup / Room EQ” menu reappears.
10
Press the CURSOR
DD
or
HH
button to select the
“Exit”, then press the
ENTER button.
• The “System Setup Menu” reappears.
7
Press the CURSOR
DD
or
HH
button to select the
“Exit”, then press the
ENTER button.
• The “Parameter Check” screen reappears.
The results of the “Auto Setup” procedure can
be reset even if the settings have been changed
after performing the “Auto Setup” procedure:
Press the
CURSOR
DD
or
HH
button to select the
“Restore Yes
0
”, then press the CURSOR
FF
button.
8
To Next Page
Loading...
