Dickey-John Seed Manager SE User Manual

36/ SETUP
OPERATOR'S MANUAL
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series® 11001-1218-200112 Rev A
29. English/Metric Units
The user selects the system of units with
this constant. The SET switch is used to
toggle between English and Metric units.
Figure 38 shows the display when Metric
units are selected. The METRIC
message is absent when English units are
selected.
CUSTOMER SETUP
CONSTANTS
The Customer Setup Constants are
entered by holding the SETUP switch
depressed, while powering on the
console and continuing to hold it
depressed until the Display Test begins.
A flashing SETUP message indicates the
console is in the Customer Setup
Constants. Press the SETUP switch to
advance to the next Customer Setup
Constant. To exit the Customer Setup
Constants, power off the console. The
different Customer Setup Constants are
listed as follows:
1. Boot Version Number
DICKEY-johns Service Department
may request the customer to observe and
record the four (4) different 4-digit
numbers (to identify the boot memory
software version) in the unlikely event
field problems occur.
The first 4-digit number shows on the
upper numeric display at the same time a
b1 identifier appears on the lower
numeric display. Record this number,
then press and release the SELECT
switch to step to the b2, b3, and bc
numbers, recording each 4-digit number
along with its identifier. To return to
b1 again press the SELECT switch.
Press SETUP to advance to the next
constant. Figure 39 shows 0197 for
b1, the first Boot Version Number.
Figure 38
Units Selection Display

Dickey-John Seed Manager SE Specifications

General

Brand	Dickey-John
Model	Seed Manager SE
Category	Measuring Instruments
Language	English