EasyManuals Logo

Dickey-John Seed Manager SE User Manual

Dickey-John Seed Manager SE
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
OPERATOR'S MANUAL
TROUBLESHOOTING/ 61
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series® 11001-1218-200112 Rev A
MONITOR DEAD
Probable Cause
1. Blown console fuse
2. Poor battery connections
3. Cut or broken battery cable
4. Low battery voltage
5. Defective Console
Corrective Action
1. Check console fuse. If blown, replace with a seven one-half (7.5) Amp, type
AGC fuse. If it blows again, contact DICKEY-john Technical Support to replace
console. See inside, back cover of this manual for phone number.
2. Clean and tighten battery connections
3. Repair by splicing, soldering, and individually heatshrinking each
wire. Use only Rosin Core Solder.
4. Verify battery voltage is at least twelve (12) volts. If not, recharge or replace
battery.
5. Contact DICKEY-john Technical Support. See inside, back cover of this manual
for phone number.
BATTERY SYMBOL APPEARS ON DISPLAY
Probable Cause
1. Low battery voltage
2. Intermittent harness short to ground
3. Poor battery connections
Corrective Action
1. Recharge or replace battery
2. Locate short and repair by splicing, soldering, and sealing the wire
3. Clean and tighten battery connections
TROUBLESHOOTING

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dickey-John Seed Manager SE and is the answer not in the manual?

Dickey-John Seed Manager SE Specifications

General IconGeneral
ModelSeed Manager SE
DisplayLCD
Power Supply12 V DC
Dimensions9.5 x 7.5 x 4.5 inches (24.1 x 19.1 x 11.4 cm)
Operating Temperature0°C to 40°C

Related product manuals