Dickey-John Seed Manager SE User Manual

OPERATOR'S MANUAL
ERROR CODES/ 59
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series® 11001-1218-200112 Rev A
The Seed Manager® SE Console
performs a Self Test upon power up
and when commanded by the user in
SETUP MODE. At the end of the Self
Test the console will either show
PASSED and cycle through all of the
seed rows, or the console will display the
SELF TEST ERROR CODES
appropriate error codes that were
detected. Figure 66 shows a complete list
of all error codes that can be displayed.
See the TROUBLESHOOTING
chapter for additional details and
recommended recovery procedures.
Error Code Description
E00 No Modules Connected
E01 Too Many Modules Connected on P1 or P2
E10 Too Few Seed Modules Connected
E11 Too Many Seed Modules Connected
E20 Too Few Shaft Modules Connected
E21 Too Many Shaft Modules Connected
E30 X Too Few Seed Sensors Connected to Module X
E31 X Too Many Seed Sensors Connected to Module X
E40 Too Few Hopper Sensors Connected
E41 Too Many Hopper Sensors Connected
E50 Too Few Pressure Sensors Connected
E51 Too Many Pressure Sensors Connected
E70 Module 8v Power Supply Too Low
E71 Module 8v Power Supply Too High
E98 Internal LCD Driver Failure
E99 Internal Bus Failure
Figure 66
Self-Test Error Codes

Dickey-John Seed Manager SE Specifications

General

Brand	Dickey-John
Model	Seed Manager SE
Category	Measuring Instruments
Language	English