Dickey-John Seed Manager SE User Manual

40/ OPERATE
OPERATOR'S MANUAL
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series® 11001-1218-200112 Rev A
desired function. Otherwise the
Population function is automatically
selected. To zero the accumulated Run
Hours, press the START STOP
RESET switch for one (1) second while
Run Hours are displayed. Figure 42
shows Run Hours of 47.5.
C. POPULATION
This is the amount of seeds, in thou-
sands of seeds per acre (hectare), sown
in a given row based, upon the most
recent sampling of the seeding rate for
that row. The Population function is
selected automatically upon power up or
Figure 42
Run Hours Display
by pressing the OPERATE 1 switch until
the POPULATION message appears
on the display. Only the seed rows that
have their row status set to ON will be
displayed in the Population function. If
the Blockage Mode is set to All Rows
Blockage, the upper numeric display will
show a series of five (5) dashes and no
population values will be available. The
Population display has several different
modes based upon the Setup configura-
tion and the scan mode that is selected.
A short description of each mode is
described as follows.

Dickey-John Seed Manager SE Specifications

General

Model	Seed Manager SE
Display	LCD
Power Supply	12 V DC
Dimensions	9.5 x 7.5 x 4.5 inches (24.1 x 19.1 x 11.4 cm)
Operating Temperature	0°C to 40°C