Dickey-John Seed Manager SE User Manual

OPERATOR'S MANUAL
OPERATE/ 45
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series® 11001-1218-200112 Rev A
9. Area Accumulator
Area Accumulator 1 and 2 are intended
to be used as field area accumulators,
displaying acres with 0.1 resolution
(hectares with 0.01 resolution). Area
Accumulator 3 is intended to be used as
a total area accumulator with the same
resolution as Area Accumulator 1 and 2.
The area calculations are based on the
Implement Width and distance traveled.
Area does not accumulate during an
ALL ROWS FAILED condition, i. e.,
when the implement is raised. This
function is selected by pressing the
OPERATE 3 switch until the AREA
message appears and a 1, 2, or 3 is
shown in the lower right corner of the
display. Area Accumulator 1 and 2 is
reset by pressing the START STOP
RESET switch for at least one (1)
second. Area Accumulator 3 is reset by
pressing the START STOP RESET
switch for at least three (3) seconds.
When a total of 9999.9 acres (999.99
hectares) is exceeded, the decimal point
shifts to the right one place. When a
total area of 99999 acres (hectares) is
exceeded, it will roll over to zero (0).
Figure 51 shows Area Accumulator 1
with 1674.3 acres.
10. Seed Count
This function is used to count the
number of seeds passing through each
seed sensor. This function is selected by
pressing the OPERATE 3 switch until
the COUNT message appears.
Press the START STOP RESET switch
to start the measurement, then press it
again to stop. The ON and OFF messag-
es on the display indicate the Seed Count
function status. To zero the accumulated
seed count on the selected row, press
and hold the START STOP RESET
switch until a beep occurs (approximately
one (1) second). To zero the seed count
for all rows, press and hold the START
STOP RESET switch for at least three
(3) seconds. When a total of 99999
counts are exceeded, the count rolls over
to zero (0). Depress the SELECT ROW
switch to advance the display to the next
row. Depress the BACK switch to
return to the previous row.
Figure 51
Area Accumulator 1 Display

Dickey-John Seed Manager SE Specifications

General

Brand	Dickey-John
Model	Seed Manager SE
Category	Measuring Instruments
Language	English