Digifly AIR-BT User Manual

Page 45
10.6 OPERATION CHECKLIST BEFORE A TASK
 Be sure that batteries are fully charged
 Download the waypoints from the competition organization web site
 Upload them on the Digifly Air with the software AirTools (PC, MAC) or GpsDump (PC , MAC, SMARTPHONE)
 Edit the route accordingly to the task’s director instruction :
o Insert the turn points cylinders radius
o Insert correctly the Start Pylon type using the parameter Wpt Type : set the value "IN" (Entering Start
Pylon) or the value "OUT" (Leaving Start Pylon). See 9.5 for more details about the Wpt Type settings.
o Insert correctly the start time
o If existing, insert also the ulterior gate time ( how may and when)
o In the route page verify that the total distance is corresponding (“Tot dst m”) , calcolata dal centro del
primo wpt al centro dell' ultimo wpt lungo la rotta non ottimizzata
 Activate the route
 Set the barometric altimeter A1, this is important as it is used also by the glide’s computer.
 Before takeoff, turn on your instrument with sufficient time to allow a correct GPS position to be obtained.
 After the GPS position has been obtained, check that the time is correct. If necessary change the time zone
otherwise the start time will be wrong. Parameter (MAIN SETUP \ n. 7 UTCO)

Digifly AIR-BT Specifications

General

Brand	Digifly
Model	AIR-BT
Category	Measuring Instruments
Language	English