Welcome to Admin Console
5
Added support for firmware updating of IP Endpoints
Improved pacing of audio paging packets for UDP and RTP operations
When sending Audio Pages via UDP Unicast, if the IP Endpoint is configured to use RTP, the
audio is sent via RTP to the IP Endpoint's dynamically assigned or Fixed RTP Port
Added the ability to use an IP Endpoint as a microphone for a Queued Paging Group
Version 2.0.2 Release December 2010
Administrator Console Changes and Corrections
Added the ability for discovery, configuration and firmware updates to "connecected" IP
Endpoints via TCP instead of UDP, so updates can now be made to IP Endpoints behind a
NAT'd Firewall
Added the ability to define a Shared RTP Listening port for IP Endpoint audio
Added the ability to define a Fixed RTP Port for IP Endpoints on the IP Endpoints -->
Options 1 sub tab
Server Corrections and Enhancements
Added support for using Fixed RTP Ports on IP7 IP Endpoints
Added support for IP Endpoint discovery and configuration to "connected" IP Endpoints
Added support for using a shared RTP Listening port for IP Endpoints
Version 2.0 Release October 2009
Administrator Console Changes and Corrections
Added the ability to define pre-recorded Messages for 1-way paging
Added the ability to define paging Groups for 1-way paging and associate pre-recorded
Messages with each Group
Added the ability to add Groups to Operators. When an Operator logs on to the Operator
Console, the Groups and their associated Messages are included on a new tab used for 1-
way audio paging
Added the ability to select the Text-to-Speech engine to be used for applications created
using the "SayText" API from the Software Development Kits
Added an Update Now option to the bottom of the screen to dynamically send most
Administrator Console updates to the Server and Operator Consoles without needing to
restart the Server service
Added an option to use the RTP protocol instead of the TCP/IP protocol to send and receive
2-way Intercom audio
Added a Managed check box to the Intercom configuration to authorize devices added to the
system
Added a Replace option on the Intercoms tab to copy the configuration of an existing
endpoint and replace it with a new endpoint
To Next Page
Loading...
