1
Welcome to Admin Console
Welcome
Welcome to the Admin Console. The Admin Console is used to configure the TalkMaster FOCUS Server
and the IP Endpoints that connect to it.
If configuring IP Endpoints to operate only with a SIP 2.0 Server, please review the eSIP Standalone
Configuration topic.
If upgrading from a previous version, please review the Release Notes topic.
For an overview of the system, please review the System Overview topic.
For an Overview of the Administrator Console, review the Administrator Console Overview topic.
Release Notes
V 6.0.2 Release August 2019
Administrator Console Changes and Corrections
Fixed an issue where the Text to Speech Engine on the Setup → File Locs tab change
would not affect the selected voice
Added the ability to suppress Call Queue Entries generated by an IP Endpoint when it’s Talk
button was pressed. This enables the Talk button to trigger an Event in the Event
Configuration Console. The new option is available on the IP Endpoints → Opt 3
tab. Device needs to be configured as call-button and no call queue entries
Fixed an issue where the IP Endpoint list would be disabled when creating a new Paging
Group on the Paging Groups → Endpoint Members tab, and the group type was changed
to queued
Fixed an issue that would prevent the removal of a fixed RTP port on the IP Endpoints →
Opt 1 tab
Improved the performance when loading tens of thousands of entries on the Audit tab
TalkMaster FOCUS Server
Fixed an issue where an IP Endpoint could be reported as being "Disconnected" to Consoles,
but the endpoint’s LEDs indicated it was “connected”. This caused issues with TalkMaster
communications, but SIP calls would still work
Improved the performance and reliability of sending RTP audio to IP Endpoints
Added .5 seconds of silence to the end of a pre-recorded audio file when sending it to one or
more IP Endpoints
Fixed a pacing issue when sending a pre-recorded audio file via TCP to an IP Endpoint
Fixed an issue which could occur after several weeks if many devices were continually
connecting and disconnecting
V 6.0 Release June 2018
To Next Page
Loading...