Digital Acoustics TalkMaster FOCUS - General Configuration and Adapters

TalkMasterFOCUSAdminConsoleReferenceManual
32
o Assign a fixed IP Address, Subnet and Gateway and specify 3000 for the Port
o On the General--> Configuration tab of the second IP Endpoint, select Client from the Type
drop down box
o Configure the Server IP and Port to the IP Address and Port assigned to the Server Intercom
o On the eSIP--> Options 1 tab, make sure both IP Endpoints have the Not a SIP Device
selected from the drop down box
 Music Injector - The IP7 IP Endpoint can be configured as a Music Injector to send low priority
Multicast background audio to other IP7s on the Network. The Injector receives analog audio input
from its Microphone or Line In connections and sends it out on the network to a specific Multicast IP
Address/Port. Any IP7 that is setup to play Background Music from that IP Address/Port will play this
audio while it is idle.
o On the General--> Configuration tab of the IP Endpoint, select Music Injector from the Type
drop down box
o On the General--> Options 1 tab, select the Input Source of the analog music source as
either Microphone or Line In
o On the General--> Options 2 tab, check the Play Multicast Background Music option
o Enter the Multicast IP Address and Port that the audio is to be sent to
o Check the PTT Sends Audio option to have the Injector send the Multicast audio when the
Injector's Talk switch is engaged. If this option is not check, the Injector will continuously send
Multicast audio
o Select the Sample Rate Multicast audio will be sent at. A higher sample rate produces better
fidelity, but also uses more bandwidth. 8000 will produce a 64kbps stream, 11025 will produce
a 88kbps stream and 22050 will produce a 176kbps stream
o Configure all IP7s that should play audio from the Music Injector by checking the Play
Multicast Background Music option and entering the same Multicast IP Address and Port
used by the Injector.
General - Configuration
The Configuration sub-tab of the IP Endpoints tab is used to update the IP Address and option
information that is saved in the IP Endpoints so they can operate on the network.
Press the Copy Defaults button to copy in the settings from the Endpoint, eSIP and WiFi Defaults.
The Save button must be pressed for these settings to be applied.