TalkMasterFOCUSAdminConsoleReferenceManual
34
Location Name - Assign a descriptive name to the IP Endpoint. This will be used to identify the Endpoint
and will be displayed on the Consoles.
Adapter In Use: - Will display Ethernet or Wireless depending on how the IP Endpoint is connected to
the network. The IP Address, Subnet Mask, Gateway and DNS Address are displayed below
Authorized IP Endpoint - This box must be checked to authorize this device to this TalkMaster Server
and allow the IP Endpoint to appear on the Operator Consoles. If an Intercom is connected to this Server
but this box is not checked, it will only appear on the Administrator Console or on an Operator's Console
defined with Administrative Rights running on the Server. If the device is configured to connect to a
Server other than this one, do not check this option
Server IP/Port - Configures the Intercom to connect to the IP address and port of the machine that the
TalkMaster FOCUS Server is running on. The Server's IP Address can be selected by clicking in the box
or a different IP address can be entered. The default port TalkMaster FOCUS Server uses to listen for IP
Endpoint connections is Port 3000
NIC Version - Firmware Version information.
ICOM Version - Firmware Version information and associated options.
Defaults button - Pressing the Defaults button copies in all of the settings from the Endpoint Defaults
and eSIP Defaults tab.
General - Adapters
The Adapters tab sub-tab of the General tab is used to specify the IP Address of the IP Endpoint. On
devices that have a Wireless adapter , it will only be available when the Ethernet port is unplugged. Only
one adapter can be active at a time. If both the Ethernet and Wireless are available, the Ethernet adapter
always takes precedence.
To Next Page
Loading...
