12 EVOLUTION 1 SYSTEM MANUAL Issue 1.1 20 Dec 2006
CONFIGURING THE PRINTER
To verify the current operating software press the STOP PRINT
key.
Press the V key
The first line indicates the version of the controller software
The second line numerics indicate printer software version and the letter is the
firmware version of the printer. The ‘+’ (s) following indicate options installed:
++++ = Fully Optioned
The third line indicates the serial number of the printer
SYSTEM RESET
Soft Reset:
There are two types of resets available in the Evolution II printing system. The
first type of reset is a SOFT RESET.
Pressing the R key while applying power to the
unit will display the reset command mode
CAUTION: A response of Y will delete all stored
messages.
The next screen to appear prompts the user to
determine if a print head is to be restored to its
default value.
CAUTION: ALL PRINT HEADS CONNECTED
TO THE CONTROLLER WILL BE RESET TO
FACTORY DEFAULT CONDITIONS. THIS
INCLUDES RESETING EACH UNIT ADDRESS
TO 1. TO PREVENT THIS REMOVE ALL
INTERCONNECTED PRINT HEADS EXCEPT
FOR THE UNIT TO BE RESET FROM THE
DATA LINK.
CONTROLLER 7.08
PRINTER 2.08K++++
PRINTER SN XXXXXX
EXIT ANY KEY
ERASE STORED
MESSAGES
ES OR NO Y/N
RESET PRINT HEAD
ES OR NO Y/N
ALL HEADS
WILL BE RESET
CONTINUE = X KEY
ANY OTHER EXITS
To Next Page
Loading...