13 EVOLUTION 1 SYSTEM MANUAL Issue 1.1 20 Dec 2006
4 - AUTO REPEAT:
This option enables the unit to continuously print
repeated codes at specified time intervals along
the entire length of the product. A time of 0
disables the Auto Repeat option. Use or
to change the repeat time. Each number in the
time delay adds or subtracts a distance equivalent to the pre-defined setting.
Save your choice by pressing . The maximum repeat spacing is 255 counts
where each count is equal to 16 character columns or 0.053”. This allows for a
total displacement of 13.46”. Setting a print delay that uses the same
mathematical equation can increase this number. Thus a total displacement of
26.92” can be realized.
< - - SELECT - - >
REPEAT TIME= 0
To Next Page
Loading...