21 EVOLUTION 1 SYSTEM MANUAL Issue 1.1 20 Dec 2006
4 – LOAD CARD:
LOADING FONTS (MENU SELECT 1)
The user can replace the existing FONT, add up
to six logos, or load optional software from a
Data Flash card, which is plugged into the top of
the print carriage. Select 1 to load a different
font to replace the current system font.
The screen to the left will appear and after a few
seconds a result will be displayed to indicate
NOTHING LOADED or the name of the newly
loaded font, logos or software upgrades.
To load or replace the current LOGOS in the
system press the key. Similar to loading
FONTS the screen at the left will appear
indicating the load results.
This screen will be displayed if the data flash
card is either not present or cannot be read.
CHECK THAT THE DATA FLASH CARD IS
PROPERLY INSTALLED
A successful load will display the current font
names loaded into the print head. This screen
will be displayed when the default fonts are
loaded.
When loading alternate fonts the AF will replace
LINE for the alternate font or fonts loaded.
NOTE: when optional fonts are loaded into the system the Data Flash Card
is encoded with the serial number of the unit and is valid only for the unit in
which the fonts were loaded.
EXECUTE LOADER
1=LOAD FONTS
2=LOAD LOGOS
3=LOAD OPTIONS
LOAD RESULTS
PLEASE WAIT
MEMORY ERROR
NO FLASH CARD
ANY KEY TO EXIT
LOAD FONT
1= LOAD DEFAULTS
2= LOAD ALTERNATE
LOAD RESULTS
2 LINE fontname
1 LINE fontname
ANY KEY TO EXIT
LOAD RESULTS
2 AF fontname
1 AF fontname
ANY KEY TO EXIT
To Next Page
Loading...