26 EVOLUTION 1 SYSTEM MANUAL Issue 1.1 20 Dec 2006
INPUT, EDIT OR DELETE MESSAGES
To input, delete or edit a message, the unit must be
in the STOPPED Mode. If the LCD reads
PRINTING, press . The screen should be
similar to the one shown at the left.
Enter the Message Entry mode by pressing .
The top portion of the screen will change as shown
on the left.
The user has two options to edit or change a
message. If a new message is to be entered press
the key to delete the entire existing message.
For example, to produce a single line of 1 LINE.
Press the font key until the 1/2 “ font size
is shown, and enter EXP followed by the
key. This enters the DATE OFFSET as
defined in the F1 menu.
To place two lines use the to select 2 LINE size.
Press the
key to delete the entire message.
Press the to select which line the data
will be entered on. Enter BEST BY. The pictorial at
the left shows two lines of 2 LINE character size. To
enter and print only 1 line of 2 LINE select the line
and enter data to that line only.
Once the message line(s) is complete, save the
change by pressing .
NOTE: USE THE DATE OFFSET KEY TO ENTER
AN EXPIRATION DATE.
MESSAGE ENTRY
FONT 1 LINE
EVOLU
EV2 STOPPED
HD1- - >SPEED=120
EVOLU
MESSAGE ENTRY
FONT 1 LINE
MESSAGE ENTRY
FONT 1 LINE
.DD.DY
MESSAGE ENTRY
FONT 2 LINE
BEST BY
EXP 12/01/2004
STOPPED
HD1- - >SPEED=120
BEST BY
EXP 12/01/2004
To Next Page
Loading...