Digital Design EVOLUTION II - Changing System Time and Date Roll over Time

5 EVOLUTION 1 SYSTEM MANUAL Issue 1.1 20 Dec 2006
CHANGING SYSTEM TIME AND DATE ROLL OVER TIME
When the unit is in the STOPPED mode
pressing the TIME
key allows the user to
change the system date. If there are no
changes press the N key to return to the
STOPPED mode.
Select the N key if the time is correct and
return to the STOPPED mode.
Press the Y key to change to the correct time.
Enter the correct hours (2 digits) followed by
the correct minutes (2 digits). The screen
displays the corrected time. Press the Y key to
make further changes or N key to return to the
STOPPED mode.
Notice the time is in 24-hour format.
The Date Change option is enabled by
selecting option 2. This feature allows the date
to roll over at a specified time other than
12:00AM (midnight). For example if the start of
a new shift day occurs at 6:00AM the date will
be changed each day at 6:00AM.
Selecting Y allows changing of the roll over
time. Setting this parameter to 00:00 disables
the function.
PRESENT SETTING
ANY CHANGES Y/N
23:05
PRESENT SETTING
ANY CHANGES Y/N
23:05
ENTER HOURS -
PRESENT SETTING
ANY CHANGES Y/N
13:50
TIME SETTINGS
1= SET TIME
2= DATE CHANGE TIME
PRESENT SETTING
ANY CHANGES Y/N
23:05
ENTER MINUTES -
TIME SETTINGS
1= SET TIME
2= DATE CHANGE TIME
DATE TIME CHANGE
ANY CHANGES Y/N
00:00