Digital Design EVOLUTION II - Evolution II Quick Setup

19 EVOLUTION 1 SYSTEM MANUAL Issue 1.1 20 Dec 2006
EVOLUTION II QUICK SETUP
Install a new cartridge. Press the following keys in order:
To reset the ink level detector press
Each time a new print cartridge is installed the system automatically profiles the
correct operating parameters for the new cartridge. These parameters set the
required voltage and on time to produce consistent results without user
intervention.
NOTE: USING OTHER THAN AUTHORIZED CARTRIDGES MAY CAUSE
UNDESIRABLE RESULTS.
Press the GREEN print enable key to enter the print mode
To set the LINE SPEED, press to put the system in the Printing mode. Set
character width by
To set the PRINT DELAY press: to put the system in the Printing mode. Set
print delay by
. NOTE: Each increment or decrement changes the delay by the pre-defined
amount.
You may continue to experiment with line speed and print delay until the desired
code registration on the product is achieved.
REMAINING INK
100 %
C NEW CARTRIDGE
OTHER KEY EXIT