Digital Projection E-Vision 6800 3D Series - Changing the Color Wheel

page 7
Digital Projection E-Vision 6800 3D Series
Installation and Quick-Start Guide
CHANGING THE LENS, LAMPS AND COLOR WHEEL
Rev A January 2015
Changing the color wheel
1. Slide open the lamp compartment cover as shown in the picture.
2. Unscrew the four captive screws securing the color wheel.
3. Remove the color wheel.
4. Insert a new color wheel.
5. Fasten the screws.
6. Replace the lamp compartment cover.
4 5 6
3
2
1
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
The color wheel must be changed
only by suitably qualied
personnel.
The projector will shut down if the
cover is opened whilst in operation.