Introduction
The projector can be controlled by using an external control system or a PC via an RS232 or LAN interface, using a terminal-emulation
program.
Network setup
1. Connect the projector to a LAN network.
2. Open the Setup > Network menu and edit network settings. The default IP address is 192.168.0.100 and the TCP port number is 7000.
Serial Port setup
• Baud rate: 9,600 bps (default), 19,200 bps or 38,400 bps.
• Data length: 8 bits
• Stop bits: one
• Parity: none
• Flow control: none
Notes
Details of how to connect to
the projector using the LAN or
RS232 input, can be found in the
Connections Guide.
Furhter details about setting up
a LAN or Serial connection and
changing network settings can be
found in the Operating Guide.
Only one control path at a time
should be used for protocol control.
Attempts to send commands to both
serial and network ports at the same
time may result in unpredicatable
behaviour.
The baud rate can be adjusted. For
details, see the Operating Guide.
To Next Page
Loading...
Need help?
General
