Chapter3: Basic Operations
Phone Call
Dial mobile phone or Extension Number
Dial the number directly and wait for 3 seconds (Default “No dial timeout”);
Dial the number directly and press #.
Direct IP Calls
THE GATEWAY with FXS port allow two parties directly call through IP address. The user
need only a simulation with the FXS port unit equipment linked together and set up calls not
registered.
Elements necessary to completing a direct IP call：
Both the GATEWAY and other VoIP Device, have public IP addresses;
Both the GATEWAY and other VoIP Device are on the same LAN using private IP
addresses;
Both the GATEWAY and other VoIP Device can be connected through a router using
public or private IP addresses (with necessary port forwarding or DMZ).
Operation Process：
Pick up the analog phone then dial “*47”
Enter the target IP address.
【Note】: No dial tone will be played between step 1 and step 2
Examples:
If the target IP address is 192.168.0.160, the dialing convention is *47, then 192*168*0*160.
Followed by pressing the “#” key or wait 3 seconds. Complete signaling interactive soon
after, he was called the unit can be heard ringing.
【Note】:You cannot make direct IP calls between FXS0 to FXS1 since they are using same
IP. It only supports the default destination port 5060.
To Next Page
Loading...
