Figure 4.3-4 RTP Session Statistics
The picture show above is real-time RTP conversation flow data information, includes:
Port, voice codec, packet period, local port, peer IP, peer port, sent packets, receive packets,
lost packets, jitter and duration.
Quick Setup Wizard
Quick configuration guide will guide users to configure the device step by step. Users only
need to configure network, SIP server and sip port in quick setup wizard. Basically, after
these three steps, users are able to make voice call through device.
Network Configuration
Local Network
The GATEWAY has two kinds of work mode: route and bridge. When the GATEWAY is set
rout mode, the GATEWAY will work as small router and NAT function has enabled. In this
situation, WAN port is normally connect to uplink router/switch or ADSL MODEM, LAN port
used to connect local computer or other network device(such as Ethernet switches, Hubs
etc.); When the GATEWAY is set bridge mode, WAN and LAN port are the same. The
GATEWAY just work as two ports or four ports Ethernet switch.
When it set to bridge mode, only need to configure WAN port IP address and DNS. If set to
route mode, default LAN port IP will display and it can be change by users. Network
configure interface as below:
To Next Page
Loading...
