Configure dynamic IP address by DHCP:
Offhook; Dial “*150*2#”; Onhook;
If the equipment hint success, after 10 seconds, and restart the equipment. (Power-off
then power-on)
Configure Static IP address:
Offhook; Dial “*150*1#”; Onhook;
Then configure IP and mask as follow:
• Configure IP address:
Offhook; input “*152*172*16*0*100# ”; onhook
• Configure subnet mask
Offhook; input “*153*255*255*0*0# ”; onhook
• Configure gateway IP address
Offhook; input “*156*172*16*0*1# ”; onhook.
• Query the IP address of device: Offhook, input“*158#”
If the THE GATEWAY serial uses PPPoE method to get IP address，it need to configure by
web browser.
【Note】：The telephone will play voice prompt “Setting successfully” if the step is correct
Chapter4: Web Configuration
Getting start
Device is connecting to network properly, refer to chapter 3 “basic Operation”. Offhook and
dial*158# to inquire device IP address.
Network connection
Device LAN port default IP address is 192.168.11.1, WAN port default obtain IP address by
DHCP. Advice to modify the IP address of the local computer equipment and ensure that are
on the same IP segment, with Windows 7 as an example, the local computer IP address
change for 192.168.11.10：
To Next Page
Loading...
