Switch between incoming calls, If not in session, flash/hook will
switch a new channel for new call.
Sending and Receiving Fax
THE GATEWAY（FXS）support four fax modes:
T.38 (FoIP)
Pass-Through
Modem
Adaptive
T. 38 and Pass-Through
T.38 is the preferred method because it is more reliable and works well in most network
conditions. If the service provider supports T.38, please use this method by selecting T.38 as
fax mode (default). If the service provider does not support T.38, pass-through mode may be
used. If you have problems with sending or receiving Fax, toggle the Fax Tone Detection
Mode setting.
Local IVR Operation
Inquire IP address
Analog phone connected with FXS ports of device, then pick up, after dial tone, dialing *158#
to inquire LAN port IP address and dialing *159# to inquire WAN port IP address.
Factory Reset
After picking up, dial *166*000000#, then onhook and restart after “Setting successful”.
Configure LAN Port’s IP Address
Before configuration, please ensure:
The device is power on;
Device is connecting to network;
Telephone is connected to FXS port of device.
To Next Page
Loading...
