Dinstar FXS - Page 40

Dinstar FXS Voice Gateway User Manual
34
user is typing in the extension then the GATEWAY will consider the
extension as complete and it will try to send to SIP server. Default
value is 4 seconds
Timeout for
answer(Outgoing call)
This timer set how long the caller party waiting when makes outgoing
call on extension.
Timeout for
answer(Incoming call)
This timer set how long the phone sets ringing when get incoming call
No RTP Detected
Detect when there’s no RTP packet receive
Period without RTP
Packet
The time interval of No RTP packet
Call Process Tone
Hear the dial tone when pick up the phone. Choose the national
standards from the drop-down box. Default is the United States.
Auto Gain Control
Enable automatic gain control
Send Polarity Reversal
Enable polarity reversal to billing.
Detect Hook flash
A protruding button where putting the receiver boards, called Flash.
Always press is hang up, pick up the receiver, the fork lift machine
from reed called, by hand clap called "Hook flash". Hook flash is a
process that put the flash fast by pressing and let go.In essence is to
cut off the dc access about 80 to 200 ms. Then switches don't think
it's hang on, but keep the call, taking some other operating. The
typical application of hook flash is the telephone switchboard. When
need to transfer the call to other extension, then telephone hook
flash to transfer the call.
CID Type
There are DTMF and FSK, General for the default.
Message Type
The call display types SDMF and MDMF, General for the default
Message Format
The call display format send to analog phone, can be “Display Name
and CID”, “CID only”, or “Display Name only”; default to “Display
Name and CID”