Dinstar FXS - Page 53

Dinstar FXS Voice Gateway User Manual
47
Inquiry WAN port IP address
Dial*159# to obtain device WAN port IP address
Inquiry Phone Number
Dial*114# to obtain port account
Inquiry PortGroup Number
Dial *115# to obtain port group number
Setting IP Mode
*150*0#, means pppmodem, *150*1#, means static IP,
*150*2#, means obtain IP address by DHCP, *150*3#, means
pppoe.
Network Work Mode
*157*0#, set network work mode to routing mode; *157*1#,
set network work mode to bridge mode
Configure IP Address
*152*+IP, set gateway IP address
Network subnet mask
configure
*153*+subnet mask, set gateway subnet mask
Network Gateway Configure
*156*+gateway IP, set gateway
Renew DHCP
*193#, set dynamic IP again
Access Web by Wan in Rout
Mode
Allow access web through WAN port：*160*1#; don’t allow
access web through WAN port：*160*0#
Reset Basic Configuration
Dial *165*000000# to restore default username/password
and network configuration
Reset Factory Configuration
*166*000000#, reset factory
Restart Device
*111#, restart device
Call holding
During a call, dial*# into call hold.（Recovery the call through
hook flash or *#）
Call by IP
Directly dial the end user IP to call
Call Waiting Activate
*51#, enable call waiting function
Call Waiting Deactivate
*50#, forbid call waiting function
Blind Transfer
If the call transfer to 801, first hook flash and then dial the *
87 * 801#