Dirui CS-T240 - Page 71

71
2
Put on protective gloves to remove fixing screws.
3
Rotate reaction disk by hand and remove the reaction cuvette sequently. Take
out reaction cuvette while rotating it.
4
Rinse the new reaction cuvette dipped in with water; rinse inside and outside
of reaction cuvette and no scratch is allowed.
5
Rotate reaction disk by hands, and mount new reaction cuvette on reaction
disk and check the six sets reaction cuvette simultaneously.
6
Mount reaction disk with the opposite steps and make sure the fixing screw of
reaction disk is tight.
7
Switch on the power of analysis part