Chapter 5: Troubleshooting
Operation Manual: Evolution Series
Message Reason
ABORT MANUAL MODE TEST.
START METHOD: METHOD_NAME
Manual mode is currently running.
Confirm aborting manual mode and start
test method.
ARE YOU SURE YOU WANT TO LOG OFF?
Confirm logging out.
ONLY A MANGER CAN
MODIFY SYSTEM PARAMETERS.
Only a manager has privileges to modify
system parameters.
VESSEL TEMP HAS BEEN REACHED.
RAISE STAGE, ATTACH BASKETS AND
LOWER STAGE TO START TEST.
(NOTE: FOR SIMULTANEOUS BASKET DROP ONLY)
Prompt when beginning a simultaneous
drop basket test.
CANNOT PRINT WHEN SYSTEM IS IDLE.
InstaPrint is not available while the
system is idle.
HOLD SHAFT # X, DROP DOSAGE FORM,
RELEASE SHAFT THEN PRESS ENTER.
Prompt for vessel position X when
starting a staggered drop paddle test.
RAISE SHAFT # X, ATTACH BASKET,
LOWER SHAFT THEN PRESS ENTER
TO CONTINUE.
Prompt for vessel position X when
starting a staggered drop basket test.
VESSEL TEMP HAS BEEN REACHED
CONTINUE?
Prompt to begin test (after pre-heat has
completed).
IS THE TCS PROPERLY PRIMED?
SELECT YES TO INITIALIZE THE HEATER.
The main unit will detect if the TCS has
gone through a power cycle (turn off
then back on). If so this warning
reminds the user to make sure the TCS
has been primed. See Priming the Pump
on page 2-8 for more information.
General Messages
Message Reason
METHOD: METHOD_NAME
HAS BEEN SUCCESSFULLY SAVED!
Confirmation of saving method settings.
CALKEY DETECTED. PLEASE ENTER
CLAIBRATION WINDOW TO READ
OR WRITE TO CALKEY.
User inserted calKEY on a screen other
than the Calibration section. Enter
Calibration section and reinsert the
calKEY.
UPDATE CALIBRATION DATA
FROM CALKEY?
Confirm updating unit calibration data
from the calKEY.
CONFIRM SAVING OF
CALIBRATION DATA TO CALKEY
Confirm updating calKEY from unit
calibration data.
To Next Page
Loading...
