Chapter 1: Introduction
Operation Manual: Evolution Series
Operation Warnings and Notes
For your safety, the information in this
manual must be followed to minimize the risk
of fire or explosion, electrical shock, or to
prevent property damage, personal injury or
loss of life.
Use this equipment only for its intended
purpose as described in this Operation Manual.
Never attempt to operate this instrument if it
is damaged, malfunctioning, partially
disassembled, or has missing or broken parts,
including a damaged cord or plug.
Improper servicing or adjustment practice can
cause equipment failure or serious physical
injury. This equipment must be adjusted and
serviced by qualified electrical maintenance
personnel who are familiar with the
construction and operation of the equipment
and the hazards involved. Take diligent care
during adjustment. All exposed points on the
control circuit boards are electrically hot with
respect to earth ground.
HIGH VOLTAGE IS EXPOSED WHEN THE
LOWER REAR PANEL IS OPENED ON THE
DISSOLUTION SYSTEM. Dangerous voltages
exist on the circuit boards when powered.
Disconnect AC power from the system while
troubleshooting. Be alert. High voltage can
cause serious or fatal injury.
All Distek Evolution 6100 heaters have
thermostatic protection. In the event of a
malfunction (or if no liquid in vessel), the
heater will cut off at approximately 150ºC.
Thermostat automatically resets after cooling
down.
Take proper precautions when handling
dissolution media. Liquid in vessel may be
HOT. Wear splash protection to avoid
exposure to scalding, acidic, caustic, or
pharmaceutical hazards. Bacteria have been
shown to thrive in certain media, especially at
test temperatures.
To Next Page
Loading...
